Table of Contents
Advertisement
Instruction Manual
D103563X012
Section 1 Introduction and Specifications
Installation, Pneumatic and Electrical Connections,
and Initial Configuration
Refer to the DVC6200 Series Quick Start Guide (D103556X012) for DVC6200p
installation, connection, and initial configuration information. If a copy of this quick
start guide is needed scan or click the field support code at the right, contact your
Emerson sales office, Local Business Partner, or visit our website at Fisher.com.
Scope of Manual
This instruction manual is a supplement to the DVC6200 Series Quick Start Guide (D103556X012) that ships with
every instrument. This instruction manual includes product specifications, reference materials, custom setup
information, calibration and maintenance procedures, and replacement part details for the DVC6200p digital valve
controller.
Note
All references to the DVC6200p digital valve controller include the DVC6205p base unit unless otherwise indicated.
Do not install, operate, or maintain a DVC6200p digital valve controller without being fully trained and qualified in
valve, actuator, and accessory installation, operation, and maintenance. To avoid personal injury or property damage,
it is important to carefully read, understand, and follow all of the contents of this manual, including all safety cautions
and warnings. If you have any questions about these instructions, contact your Emerson sales office or Local Business
Partner before proceeding.
Conventions Used in this Manual
Throughout this document, parameters are typically referred to by their common name or label.
Description
DVC6200p digital valve controllers are communicating, microprocessor‐based instruments. In addition to the
traditional function of converting a digital signal to a pneumatic output pressure, the DVC6200p digital valve
controller, using PROFIBUS PA communications protocol, gives easy access to information critical to process operation
as well as process control. It includes AO, AI, DO, and two DI function blocks in addition to the physical and transducer
blocks.
Using a compatible profibus configuration device, you can obtain information about the health of the instrument. You
can also obtain asset information about the actuator or valve manufacturer, model, and serial number. You can set
input and output configuration parameters and calibrate the instrument.
Using the PROFIBUS protocol, information from the instrument can be integrated into control systems.
The DVC6200p can be mounted on single or double‐acting sliding‐stem actuators, as shown in figure 1‐1, or on rotary
actuators. It can also be integrally mounted to the Fisher GX control valve and actuator system, as shown in figure 1‐2.
The DVC6200p mounts on most Fisher and other manufacturers' rotary and sliding‐stem actuators.
Introduction and Specifications
Scan or click
to access
field support
June 2017
3
Advertisement
Table of Contents
Troubleshooting
