Units; Security; Classic View - Fisher FIELDVUE DVC6200p Instruction Manual

Configuration
June 2017
D Field Serial Number— enter the instrument serial number.

Units

Select the appropriate units for your application.
D Temperature Unit— _C or _F
D Pressure Unit— psig, kPa, Bar, inHg, inH
D Travel Unit— cm, mm, inch, or deg
D Length Unit— cm, mm, or inch
D Area Unit— in
2 2
, cm , or mm
D Spring Rate Unit— lbsSin or NSm

Security

Write Locking— select the appropriate level of software write protection.
D Acyclic Writeable— all parameters are writeable (not locked).
D Acyclic Write Refused— acyclic writes to all parameters are denied, except WRITE_LOCKING, TAB_ENTRY and
ACTUAL_POST_READ_NUMBER parameter.
Protection
To configure a parameter in the digital valve controller Protection must be set at or above that parameters protection
level. In addition, protection is provided for various transducer block parameters, as indicated in the Protect Category
column of table C‐3, to prevent inadvertently overwriting key data by the host system or user.
D None— will not protect any transducer block parameters.
D Calibration— will protect only Calibration transducer block parameters.
D Setup and Calibration— will protect only Setup and Calibration transducer block parameters.
D All— will protect all transducer block parameters.
Note
Device Setup Auto Travel and Manual Travel automatically change transducer block protection for the user.
See table C‐3 for individual parameter details.

Classic View

Classic view allows you to view all of the variables in the Physical, Transducer, and function blocks.
26
O, or kg/cm
2
2
2
Instruction Manual
D103563X012