Fisher FIELDVUE DVC6200p Instruction Manual page 109

Instruction Manual
D103563X012
Table C‐1. Analog Output Function Block Parameter Definitions
Label
PARAMETER_NAME
SIMULATE_STATUS
SIMULATE_VALUE
SIMULATE_ENABLE
INCREASE_CLOSE
OUT
VALUE
STATUS
OUT_SCALE
EU_AT_100%
EU_AT_0%
UNITS_INDEX
DECIMAL_POINT
Reserved by PI
Process Variable
PV
VALUE
STATUS
I/O Options
IO_OPTS
Index RO / Block
Number RW Mode
35.1
35.2
0: Disabled
35.3
<>0: Enabled
0: Rising- increasing
setpoint results in
OPENING of valve
36 RW ALL
1: Falling - increasing
setpoint results in
CLOSING of valve
37 RW MAN
37.1 OUT_SCALE +/- 10%
37.2
38 RW
38.1
38.2
at least mm, degrees,
38.3
%
38.4
39-48
49 RO
Octet 1:
0: Reserved
1: SP tracks
READBACK in Man
2-3: Reserved
4: SP Tracks retained
50 RW OOS
target in MAN
5-6: Reserved
7: Use FSAFE_VALUE
on restart
Octet 2:
0 - 7: Reserved
Initial
Range
Value
0
0
0
0
Dynamic
0
0x80
100
0
%
2
Extended Parameters
0
0
0x0000
Blocks— AO Function Block
Description
Data Type: Unsigned8
Status written by an operator to simulate Transducer
block value status
Data Type: Float
Value written by an operator to
simulate Transducer block value.
Data Type: Unsigned8
Switch to enable or disable simulation.
Data Type: Unsigned8
Direction of positioner in RCAS and AUTO mode.
Data Type: 101
Value showing the desired valve position in
engineering units in RCAS and AUTO mode, and is
the value specified by the operator in MAN and LO
mode.
Data Type: Float
Data Type: Unsigned8
Indicates validity of VALUE.
Data Type: DS‐36
Conversion of the OUT parameter in percent to
OUT in engineering units as the output value of the
block. The high and low scale values, engineering
unit code, and the number of decimal points.
Data Type: Float
Data Type: Float
Data Type: Unsigned16
Data Type: Integer8
Data Type: 101
Actual valve position in PV units.
Data Type: Float
Data Type: Unsigned8
Indicates validity of VALUE.
Data Type: Octet String
User options for Output Control.
Bit 4 can not be set with bit 1
Retained target will be the the current target mode
if the actual mode is MAN. If the target mode is
RCAS, SP will track RCAS_IN parameter.
June 2017
107