Table of Contents
Advertisement
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
IP Alias List
After setting up the WAN interface, click Next to setup the LAN interface continuously.
IP Address
Subnet Mask
Status
Start IP
End IP
Primary DNS
Secondary DNS
Lease Time (Min)
Gateway IP (Optional)
Next, click DHCP Relay Agent tab to set DHCP server if required.
Vigor3300V+ Series User's Guide
Type a private IP address to the WAN interface.
Type a subnet mask value to the WAN interface.
Type a private IP address to the gateway.
Type a private IP address to the primary DNS.
Type a private IP address to the secondary DNS.
Type other IP addresses to be bound to this interface. This
setting is optional. If you have typed addresses here, you can
see and choose it in later web page settings (e.g., Advanced
>> NAT>>Port Redirection/DMZ Host). Thirty-two IP
addresses settings are allowed at one time.
Type an IP address for the LAN interface.
Type the subnet mask for the LAN interface.
Click Enable to use DHCP server; click Disable to close
DHCP server; click Relay Agent to activate relay agent
function.
Type the start IP address of the IP pool that DHCP server can
use for clients in LAN.
Type the end IP address of the IP pool that DHCP sever can
use for clients in LAN.
Type the IP address for primary DNS.
Type a private IP address to the secondary DNS.
Set a lease time for the DHCP server. The time unit is minute.
Set a gateway IP address for the DHCP server.
15
Advertisement
Table of Contents
