Table of Contents
Advertisement
NAT Traversal
WAN Interface
Netbios Naming
Packet
Local Certificate
Security Gateway
Network IP /
Subnet Mask
Next Hop
Remote ID
DHCP-over-IPSEC
Security Gateway
Network IP /
Subnet Mask
For Advanced Configuration
Click Advanced tab. The following page of default configuration will be shown:
Vigor3300V+ Series User's Guide
authenticated.
Click Enable to let multi IPSec tunnels passing through this
router.
Click Disable to close this function.
The WAN interface to be used.
Pass – Click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel while
connecting.
Block – When there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, such function can
block data transmission of Netbios Naming Packet inside the
tunnel.
The local certificate is active for authentication if the RSA
Signature option is selected in the Authentication field.
These options come from the user certificate file.
The IP address of the local gateway's public-network interface.
The keyword "default" can be used to represent the IP Address
of the selected "WAN Interface".
The subnet behind the local gateway.
The IP address of the next hop. The keyword default can be
used to represent the gateway IP address of the selected WAN
Interface.
The identification number for the remote gateway.
Turns this function ON or OFF.
The IP address of the remote client/gateway. This field is
mandatory. The setting for 0.0.0.0 is used for the road-warrior
with a dynamic IP address.
The subnet behind the remote gateway. If the remote gateway
IP address is 0.0.0.0, this field can be omitted, but you can
specify it as 0.0.0.0/32 for clarity.
163
Advertisement
Table of Contents
