Table of Contents
Advertisement
Start IP
End IP
Session Number
Edit
Delete/Delete All
To edit an entry, select it by clicking the radio button (from 1 to 10). Then click the Edit
button on the bottom to bring up the following Web page.
Start IP
End IP
Session Number
Apply After finishing the configuration, please click this button to invoke these settings.
Vigor3300V+ Series User's Guide
Display the start IP address.
Display the end IP address.
Display the session number.
Click this button to open the edit page for adjusting the
settings.
Click this button to delete the selected setting or all settings. A
confirmation dialog box will appear. Click OK to delete this
entry from the Load Balance Policy table. In addition, click
Delete All in the Load Balance Policy page to delete all of 10
entries on this page.
Assign the start IP address for limit session.
Assign the end IP address for limit session.
Assign the available session number for each host in the
specific range of IP addresses. If you do not set the session
number in this field, the system will use the default session
limit for the specific limitation you set for each index.
121
Advertisement
Table of Contents
