Table of Contents
Advertisement
Detect Destination Host
(IP or Domain Name)
IP Alias List
Apply
Reset
D
H
C
P
D
H
C
P
If the WAN interface is set as a DHCP client, the Vigor3300 Series will ask for IP network
settings from the DHCP server or DSL modem automatically. In general, it is not necessary
for users to manually configure the router. However, users can modify Connection
Detection if required.
Connection Detection
Vigor3300V+ Series User's Guide
received by the router, the connection of WAN interface will
be regarded as breaking down.
Assign an IP address or Domain name as a destination to be
detected whether the host is active (sending reply to the
router) or not. If not, the connection of WAN interface will be
regarded as breaking down. This function is available when
Detect Type is set with Send PING or Send Http Request.
Set other IP addresses binding in this interface. You can set up
to 32 sets of IP alias settings. If you have typed addresses here,
you can see and choose it in later web page settings (e.g.,
Advanced >> NAT>>Port Redirection/DMZ Host).
Click Apply to go back to the WAN Interface Configuration
page. To apply all settings, click Apply on the WAN Interface
Configuration page and reboot your router.
Click this button to clear all the configurations for this page.
C
l
i
e
n
t
S
e
t
u
p
C
l
i
e
n
t
S
e
t
u
p
Detect Type - Select a detecting type for this WAN interface.
There are three ways Send ARP to Gateway, Send PING
and Send HTTP Request supported in the router.
Detect Interval (sec) - Assign an interval period of time for
each detecting. The minimum value is 3 and no limit for
maximum value.
No-Reply Count - Assign detecting times to ensure the
105
Advertisement
Table of Contents
