Figure 49: Attaching A Cable Guard To An Ex2300-C Switch - Juniper EX2300-C Hardware Manual

EX2300-C and EX2300 Switches Hardware Guide
150
Place the surface made of ferrous material in its permanent location, allowing adequate
clearance for airflow and maintenance.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines" on page
Ensure that you have the following parts and tools available:
Magnet-mount kit (separately orderable). The kit includes 2 self adhesive rubber pads
and 1 magnet mount sheet.
At least 2-mm thick flat surface made of ferrous material (not provided)
(Optional and separately orderable) 1 cable guard kit. The kit includes the cable guard
and 3 number-8 Phillips truss-head screws to secure the cable guard to the EX2300-C
switch.
(Optional and separately orderable) 1 standard cable lock kit to secure the switch from
theft by connecting the cable to the security slot on the switch and a desk or a rack to
fasten the cable lock. The kit includes the standard cable lock and its key.
To mount the switch on or under a surface made of ferrous material:
Remove the switch from the shipping carton (see
1.
page 123).
Turn the chassis upside down.
2.
(Optional) Attach the cable guard to protect cable connections:
3.
Use the 3 truss-head screws to attach the cable guard to the bottom of the chassis.
a.
Use the thumbscrews to tighten or loosen the cable guard so that you can insert
b.
cables. See Figure 49 on page

Figure 49: Attaching a Cable Guard to an EX2300-C Switch

1— Cable guard
Attach the self adhesive rubber pads provided with the magnet-mount kit to the
4.
bottom of the switch as shown in
223, with particular attention
232.
"Unpacking an EX2300 Switch" on
150.
2— Thumb screws
Figure 50 on page 151.
Copyright © 2017, Juniper Networks, Inc.