Screws; Figure 31: Securing The Ex2300-C Switch By Using The Security Slot - Juniper EX2300-C Hardware Manual

Related
Documentation
Mounting an EX2300-C Switch Under a Desk or Other Level Surface by Using Screws
Copyright © 2017, Juniper Networks, Inc.
Ensure that the switch rests firmly on the desk or level surface.
4.
(Optional; applies only to EX2300-C switches) Attach the standard cable lock to the
5.
security slot on the switch:
Fasten the cable to a desk or a rack and set the lock to unlocked position using the
a.
key.
Insert the lock into the security slot on the switch and set the lock to the locked
b.
position using the key. See

Figure 31: Securing the EX2300-C Switch by Using the Security Slot

Connecting AC Power to an EX2300 Switch on page 161
Connecting DC Power to an EX2300 Switch on page 163
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 179
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 182
Clearance Requirements for Airflow and Hardware Maintenance for EX2300 Switches
on page 61
You can mount an EX2300-C switch under a desk or other level surface by using the
mounting slots on the bottom of the chassis and desk-mounting screws to secure the
switch.
Before mounting the switch under a desk or other lever surface by using screws:
Verify that the site meets the requirements described in
for EX2300 Switches" on page
Place the desk in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines" on page
Remove the switch from the shipping carton (see
page 123).
Figure 31 on page 131.
"Site Preparation Checklist
51.
223, with particular attention
232.
"Unpacking an EX2300 Switch" on
Chapter 12: Installing the Switch
131