EX2300-C and EX2300 Switches Hardware Guide
Table 9: Link/Activity LED on the RJ-45 Network Ports and the Uplink Ports in EX2300 Switches
LED
Color
Link/Activity
Green
Table 10: Status LED on the RJ-45 Network Ports in EX2300 Switches
Port Parameters
Speed (
SPD
)
Duplex mode (
DX
)
Administrative status (
)
EN
20
Table 9 on page 20
describes the Link/Activity LED.
State and Description
Blinking—The port and the link are active, and there is link activity.
On steadily—The port and the link are active, but there is no link activity.
Off—The port is not active.
Figure 19 on page 20
shows the LEDs that indicate the status of one of the four port
parameters—speed, duplex mode, administrative status, and Power over Ethernet (PoE)
status. Use the Factory Reset/Mode button on the far right side of the front panel to
toggle the Status LED to show the different port parameters for RJ-45 network ports.
You can tell which port parameter is indicated by the Status LED by looking at which port
status mode LED (
SPD
,
DX
switch models with RJ-45 network ports that do not provide PoE.
Figure 19: Port Mode LEDs on EX2300 Switches
1
1— Port mode LEDs
Table 10 on page 20
describes the Status LED on the RJ-45 network ports.
State and Description
Indicates the speed. The speed indicators are:
Unlit—10 Mbps
Blinking—100 Mbps
On steadily—1000 Mbps
Indicates the duplex mode. The status indicators are:
Green—Port is set to full-duplex mode.
Unlit—Port is set to half-duplex mode.
Indicates the administrative status. The status indicators are:
Green—Port is administratively enabled.
Unlit—Port is administratively disabled.
,
EN
, and
PoE
) is lit. The LED labeled
PoE
is not available on
Copyright © 2017, Juniper Networks, Inc.