Performing Initial Configuration; Ex2300 Switch Default Configuration - Juniper EX2300-C Hardware Manual

CHAPTER 15

Performing Initial Configuration

EX2300 Switch Default Configuration

Copyright © 2017, Juniper Networks, Inc.
EX2300 Switch Default Configuration on page 173
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 179
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 182
Reverting to the Default Factory Configuration for the EX Series Switch on page 186
Each EX Series switch is programmed with a factory-default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file for an EX2300 switch configures Ethernet switching and storm control
on all interfaces, configures Power over Ethernet (PoE) on all interfaces of models that
provide PoE, and enables the LLDP, LLDP-MED, and RSTP protocols and IGMP snooping.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory-default
configuration—EX2300 switches do not have LCD panel, use the CLI commands to revert
to the factory-default configuration. See
for the EX Series Switch" on page
The following factory-default configuration file is for an EX2300 switch with 24 ports
with PoE capability.
NOTE: The factory-default configuration file is different for different EX2300
switch models.
The number of interfaces in the default configuration file depends on the
number of ports in the EX2300 switch.
The statement does not appear for models without PoE.
poe
Uplink ports on EX2300 switches except EX2300-C switches are listed as
to
ge-0/1/0 ge-0/1/3
switches as
ge-0/1/0
system {
auto-snapshot;
"Reverting to the Default Factory Configuration
186.
and to . Uplink ports on EX2300-C
xe-0/1/0 xe-0/1/3
to and to
ge-0/1/1 xe-0/1/0
.
xe-0/1/1
173