Reverting To The Factory-Default Configuration By Using The Lcd Panel - Juniper EX2300-C Hardware Manual

Reverting to the Factory-Default Configuration by Using the LCD Panel

Copyright © 2017, Juniper Networks, Inc.
TIP: If you have lost the root password, it is not necessary to revert to the
factory-default configuration to reset it. See Troubleshooting Loss of the Root
Password.
The factory-default configuration contains the basic configuration settings for the switch.
This is the first configuration of the switch and it is loaded when the switch is first powered
on. For the factory-default configuration file for your switch, see the hardware
documentation for your switch.
TIP: You can run the EZsetup script to complete the initial configuration of
the switch after reverting to the factory-default configuration. (The EZsetup
script is available only on fixed configuration switches, it is not available on
modular switches.) For information on completing the initial configuration
using either the CLI or the J-Web interface, see
an EX Series Switch (CLI Procedure)" on page 179
Configuring an EX Series Switch (J-Web Procedure)" on page
You can revert to the factory-default configuration by using the
of the LCD panel or by using the
factory-default configuration command. (If your switch model does not have an LCD
panel, use these commands.) You can also use the
revert to the factory-default configuration file that contains all default settings except
the root password setting, which is retained.
These procedures are described in the following sections:
Reverting to the Factory-Default Configuration by Using the LCD Panel on page 187
Reverting to the Factory-Default Configuration by Using the request system zeroize
Command on page 188
Reverting to the Factory-Default Configuration by Using the load factory-default
Command on page 189
Reverting to the Factory-Default Configuration by Using the Factory Reset/Mode
button on EX2300 and EX3400 Switches on page 190
To set the switch to the factory-default configuration, use the LCD panel and buttons
on the front panel of the switch shown in
not have an LCD panel, use one of the procedures described in the following sections.
Chapter 15: Performing Initial Configuration
operational command or the
request system zeroize
load factory-default
Figure 69 on page
"Connecting and Configuring
or "Connecting and
182.
button to the right
Menu
load
command to
188. If the switch model does
187