Figure 1: Front Panel Of An Ex2300-C Switch With 12 Gigabit Ethernet Ports With; Figure 2: Front Panel Of An Ex2300-C Switch With 12 Gigabit Ethernet Ports - Juniper EX2300-C Hardware Manual

EX2300-C and EX2300 Switches Hardware Guide
6
Two built-in 10-Gigabit Ethernet uplink ports. You can use the uplink ports to forward
network traffic or configure them as VCPs to interconnect EX2300 switches into a
Virtual Chassis.
One electrostatic discharge (ESD) point
Figure 1 on page 6 shows the front panel of an EX2300-C switch with 12 Gigabit Ethernet
ports with PoE capability and
switch with 12 Gigabit Ethernet ports without PoE capability.
Figure 1: Front Panel of an EX2300-C Switch with 12 Gigabit Ethernet
Ports with PoE Capability
1— RJ-45 network ports
2— USB port
3— Management Ethernet port
4— Chassis status LEDs
5— Port status mode LEDs. The LED labeled
PoE is present only on models with PoE
capability.
Figure 2: Front Panel of an EX2300-C Switch with 12 Gigabit Ethernet
Ports without PoE Capability
1— RJ-45 network ports
2— USB port
3— Management Ethernet port
4— Chassis status LEDs
5— Port status mode LEDs
Figure 2 on page 6 shows the front panel of an EX2300-C
6— Factory Reset/Mode button
7— Mini-USB console port
8— RJ-45 console port
9— 10-Gigabit Ethernet uplink ports
10— ESD point
6— Factory Reset/Mode button
7— Mini-USB console port
8— RJ-45 console port
9— 10-Gigabit Ethernet uplink ports
10— ESD point
Copyright © 2017, Juniper Networks, Inc.