Related
Documentation
Connecting and Configuring an EX Series Switch (CLI Procedure)
Copyright © 2017, Juniper Networks, Inc.
interface ge-0/0/19;
interface ge-0/0/20;
interface ge-0/0/21;
interface ge-0/0/22;
interface ge-0/0/23;
interface ge-0/1/0;
interface xe-0/1/0;
interface ge-0/1/1;
interface xe-0/1/1;
interface ge-0/1/2;
interface xe-0/1/2;
interface ge-0/1/3;
interface xe-0/1/3;
}
}
poe {
interface all;
}
Configuration Files Terms
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 179
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 182
Understanding Configuration Files for EX Series Switches
EX2300 Switches Hardware Overview on page 3
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
NOTE:
EX2200-24T-4G-DC switches do not support switch connection and
configuration through the J-Web interface.
This topic describes the CLI procedure.
NOTE:
To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See
"Reverting to the Default Factory Configuration for the EX Series Switch"
on page
186.
Using the CLI, set the following parameter values in the console server or PC:
Baud rate—9600
Flow control—None
Chapter 15: Performing Initial Configuration
ezsetup
script, the switch must have the factory-default
, revert to the factory-default configuration.
ezsetup
179