CHAPTER 11
Unpacking the Switch
Unpacking an EX2300 Switch
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Unpacking an EX2300 Switch on page 123
Parts Inventory (Packing List) for an EX2300 Switch on page 124
Registering Products—Mandatory for Validating SLAs on page 125
EX2300 switches are shipped in a cardboard carton, secured with foam packing material.
The carton also contains an accessory box.
CAUTION:
EX Series switches are maximally protected inside the shipping
carton. Do not unpack the switches until you are ready to begin installation.
To unpack the switch:
Move the shipping carton to a staging area as close to the installation site as possible,
1.
but where you have enough room to remove the system components.
Position the carton so that the arrows point up.
2.
Open the top flaps on the shipping carton.
3.
Remove the accessory box and verify the contents in it against the parts inventory on
4.
the label attached to the carton.
Pull out the packing material holding the switch in place.
5.
Verify the chassis components received against the packing list included with the
6.
switch. An inventory of parts provided with the switch is provided in
(Packing List) for an EX2300 Switch" on page
Save the shipping carton and packing materials in case you need to move or ship the
7.
switch later.
Mounting an EX2300 Switch on page 128
Installing and Connecting an EX2300 Switch on page 127
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 179
"Parts Inventory
124.
123