Table of Contents
Advertisement
EX2300-C and EX2300 Switches Hardware Guide
162
To connect AC power to the switch:
Squeeze the two sides of the power cord retainer clip and insert the L-shaped ends
1.
of the wire clip into the holes in the bracket above and below the AC power cord inlet
on the rear panel (see
Figure 56 on page 162
The power cord retainer clip extends out of the chassis by 3 in. (7.62 cm).
Locate the power cord or cords shipped with the switch; the cords have plugs
2.
appropriate for your geographical location. See
EX2300 Switches" on page
WARNING:
Ensure that the power cord does not drape where people can
trip on it or block access to switch components.
Insert the coupler end of the power cord into the AC power cord inlet on the rear panel.
3.
Push the power cord into the slot in the adjustment nut of the power cord retainer
4.
clip. Turn the nut until it is tight against the base of the coupler and the slot in the nut
is turned 90° from the top of the switch (see
Figure 59 on page
163).
If the AC power source outlet has a power switch, set it to the off (
5.
Insert the power cord plug into an AC power source outlet.
6.
If the AC power source outlet has a power switch, set it to the on (
7.
Figure 56: Connecting an AC Power Cord Retainer Clip to the AC Power
Cord Inlet on EX2300-C Switches
Figure 57: Connecting an AC Power Cord Retainer Clip to the AC Power
Cord Inlet on EX2300 Switches Except EX2300-C Switches
and
Figure 57 on page
"AC Power Cord Specifications for
68.
Figure 58 on page 163
Copyright © 2017, Juniper Networks, Inc.
162).
and
) position.
0
|
) position.
Hide quick links:
Advertisement
Table of Contents
