Table 11: Status Led On The Uplink Ports In Ex2300 Switches - Juniper EX2300-C Hardware Manual

Table 10: Status LED on the RJ-45 Network Ports in EX2300 Switches (continued)
Port Parameters
PoE status ( )
PoE

Table 11: Status LED on the Uplink Ports in EX2300 Switches

LED
Status LED
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
State and Description
Indicates the PoE status. The status indicators are:
On steadily—PoE is enabled on the port and a device is drawing power.
Blinking—PoE is enabled on the port, but no power is drawn from the port.
Unlit—PoE is not enabled on the port.
NOTE: The PoE Status LED is available on the following EX2300 switch models:
EX2300-C-12P
EX2300-24P
EX2300-48P
The uplink ports operate in full-duplex mode and PoE is not applicable on uplink ports.
The Status LED on uplink ports indicate the Speed (
Table 11 on page 21 describes the Status LED on the uplink ports.
State and Description
Indicates the speed and administrative status. The indicators are:
On steadily—10 Gbps
Blinking—1 Gbps
Unlit—The port is administratively disabled or the link is down.
You can tell which port parameter is indicated by the Status LED on RJ-45 network ports
and uplink ports by issuing the operational mode command
EX2300 Switches Hardware Overview on page 3
Configuring Gigabit Ethernet Interfaces (CLI Procedure)
Configuring Gigabit Ethernet Interfaces (J-Web Procedure)
Chapter 2: Chassis Components and Descriptions
) and Administrative status (
SPD
show chassis led
).
EN
.
21