Figure 42: Attaching A Cable Guard To An Ex2300-C Switch - Juniper EX2300-C Hardware Manual

EX2300-C and EX2300 Switches Hardware Guide
142
To mount the switch on a wall:
Remove the switch from the shipping carton (see
1.
page 123).
(Optional) Attach the optional cable guard to protect cable connections:
2.
Use the 3 truss-head screws to attach the cable guard to the bottom of the chassis.
a.
Use the thumbscrews to fasten or loosen the cable guard so that you can insert
b.
cables. See Figure 42 on page

Figure 42: Attaching a Cable Guard to an EX2300-C Switch

1— Cable guard
Install three mounting screws on the wall as shown in
3.
NOTE: Figure 43 on page 143
switch when the switch is viewed from the top. The internal components
and top cover are not shown.
"Unpacking an EX2300 Switch" on
142.
2— Thumb screws
Figure 43 on page
shows the bottom panel of an EX2300-C
Copyright © 2017, Juniper Networks, Inc.
143.