Figure 34: Removing The Screws Holding The Cover; Figure 35: Attaching Mounting Rails To The Qfx10002 Switch Chassis - Juniper QFX10002 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
Using a Philips screwdriver, remove the six screws on each side of the chassis that
3.
holds the cover to the chassis. See
screws. Set the screws aside.

Figure 34: Removing the Screws Holding the Cover

Align the holes in the mounting rail with the holes on one side of the chassis. See
4.
Figure 35 on page 95 for the proper position and alignment of the rail for the QFX10002
device.

Figure 35: Attaching Mounting Rails to the QFX10002 Switch Chassis

31
Attach the mounting rail to the switch using 11 mounting screws. You may either use
5.
the screws from the mounting kits or the screws that were removed from the cover.
Tighten the screws.
Repeats steps 4 and 5 on the opposite side of the switch. A few mounting screws are
6.
extra.
Either use a mechanical lift or have two people grasp both sides of the switch, lift it,
7.
and position it in the rack so that the front bracket is aligned with the rack holes.
Have a another person secure the front of the switch to the rack using 8 chassis screws
8.
(and cage nuts and washers if your rack requires them.) Tighten the screws. See
Figure 36 on page 96 for an example of connecting the mounting rails and blades.
Chapter 3: Initial Installation and Configuration
Figure 34 on page 95 for the location of these
95