Electrical Safety Guidelines And Warnings; General Electrical Safety Guidelines And Warnings - Juniper EX2300-C Hardware Manual

CHAPTER 25

Electrical Safety Guidelines and Warnings

General Electrical Safety Guidelines and Warnings

Copyright © 2017, Juniper Networks, Inc.
General Electrical Safety Guidelines and Warnings on page 251
Action to Take After an Electrical Accident on page 252
Prevention of Electrostatic Discharge Damage on page 253
AC Power Electrical Safety Guidelines on page 254
AC Power Disconnection Warning on page 255
DC Power Electrical Safety Guidelines for Switches on page 256
DC Power Disconnection Warning on page 259
DC Power Grounding Requirements and Warning on page 260
DC Power Wiring Sequence Warning on page 261
DC Power Wiring Terminations Warning on page 263
Multiple Power Supplies Disconnection Warning on page 264
TN Power Warning on page 264
WARNING: Certain ports on the device are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE) and require isolation from the exposed outside plant (OSP)
cabling. To comply with NEBS requirements and protect against lightning
surges and commercial power disturbances, the intrabuilding ports must not
be metallically connected to interfaces that connect to the OSP or its wiring.
The intrabuilding ports on the device are suitable for connection to
intrabuilding or unexposed wiring or cabling only. The addition of primary
protectors is not sufficient protection for connecting these interfaces
metallically to OSP wiring.
CAUTION: Before removing or installing components of a device, attach an
electrostatic discharge (ESD) grounding strap to an ESD point and place the
other end of the strap around your bare wrist. Failure to use an ESD grounding
strap could result in damage to the device.
251