Reverting To The Factory-Default Configuration By Using The Load Factory-Default Command - Juniper EX2300-C Hardware Manual

Reverting to the Factory-Default Configuration by Using the load factory-default Command

Copyright © 2017, Juniper Networks, Inc.
To revert to the factory-default configuration by using the
command:
user@switch> request system zeroize
1.
warning: System will be rebooted and may not boot without configuration
Erase all data, including configuration and log files? [yes,no] (yes)
Type yes to remove configuration and log files and revert to the factory-default
2.
configuration.
NOTE: The
auto-image-upgrade
hierarchy level when you use this procedure, and thus the automatic image
upgrade feature is made available on the switch.
The command is a standard Junos OS configuration command that
load factory-default
replaces the current active configuration with the factory-default configuration (except
the root password setting, which by default is not set but which you must set in order to
commit the new configuration in this procedure).
If you want to run the EZsetup script to complete the initial configuration of the switch
after you revert to the factory-default configuration, do not use the
command. Instead do the reversion using either the LCD panel or the
zeroize command. If you use the
factory-default configuration, the configuration for the root password is retained and
the EZsetup script will not run. (The EZsetup script is available only on fixed configuration
switches, it is not available on modular switches.)
NOTE: The load factory-default
EX3300, EX4200, EX4500, and EX4550 switches configured in a Virtual
Chassis.
To revert to the factory-default configuration by using the
NOTE: If you use this procedure, you must delete the system commit factory
settings, set the root password, and commit the configuration. These steps
are not required when you revert to the factory-default configuration by using
request system zeroize
to the configuration when you use this procedure; it is added to the
configuration when you use
[edit]
1.
user@switch# load factory-default
[edit]
2.
user@switch# delete system commit factory-settings
Chapter 15: Performing Initial Configuration
request system zeroize
statement is added under the
load factory-default command to revert to the
command by itself is not supported on
load factory-default
. Also, the auto-image-upgrade
request system zeroize
[edit chassis]
load factory-default
request system
command:
statement is not added
.
189