Mounting An Ex2300 Switch Except The Ex2300-C Switch And The Ex2300-24Mp And Ex2300-48Mp Models On A Wall - Juniper EX2300 Series Hardware Manual

b. Insert the lock into the security slot on your chassis and set the lock to the locked position using
the key. See Figure
Figure 65: Securing the EX2300-C Switch by Using the Security Slot
Mounting an EX2300 Switch Except the EX2300-C Switch and the EX2300-24MP
and EX2300-48MP Models on a Wall
Before mounting the switch on a wall:
• Verify that the site meets the requirements described in
Switches" on page 53.
General Safety Guidelines and Warnings
• Read
Lifting Guidelines
.
Ensure that you have the following parts and tools available:
• 2 wall-mounting brackets (provided in the wall-mount kit)
• 12 wall-mounting bracket screws (provided in the wall-mount kit)
• 6 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not provided)
• Hollow wall anchors rated to support up to 75 lb (34 kg) if you are not screwing the screws directly
into wall studs (not provided)
• Phillips (+) screwdriver, number 2
You can mount an EX2300 switch except the EX2300-C switch and the EX2300-24MP and
EX2300-48MP models on a wall by using the separately orderable wall-mount kit.
To mount the switch on a wall:
1. Remove the switch from the shipping carton (see
16.
, with particular attention to
"Site Preparation Checklist for EX2300
"Unpacking an EX2300 Switch" on page
Chassis and Component
101).
124