Table of Contents
Advertisement
EX2300-C and EX2300 Switches Hardware Guide
Reverting to the Factory-Default Configuration by Using the request system zeroize Command
188
Figure 69: EX Series Switch LCD Panel
NOTE:
To revert a member switch of a Virtual Chassis to the factory-default
configuration, first disconnect the cables connected to the Virtual Chassis
ports (VCPs) to avoid affecting Virtual Chassis configuration parameters
(member ID, mastership priority, and setting of VCP uplinks) on other
members. See
"Disconnecting a Fiber-Optic Cable from a Device" on page
Disconnecting a Virtual Chassis Cable from an EX4200 Switch, or Disconnecting
a Virtual Chassis Cable from an EX4500 Switch.
To revert to the factory-default configuration by using the LCD panel:
Press the
Menu
button until you see MAINTENANCE MENU on the panel.
1.
Press the
button.
2.
Enter
Press
Menu
until you see FACTORY DEFAULT.
3.
Press
. The display says RESTORE DEFAULT?
4.
Enter
Press
Enter
. The screen flashes
5.
idle menu.
Complete the initial configuration of the switch. See
6.
EX Series Switch (CLI Procedure)" on page 179
Series Switch (J-Web Procedure)" on page
The
request system zeroize
that removes all configuration information and resets all key values. The operation unlinks
all user-created data files, including customized configuration and log files, from their
directories. The switch then reboots and reverts to the factory-default configuration.
To completely erase user-created data so that it is unrecoverable, use the
command.
zeroize media
CAUTION:
Before issuing
command to back up the files currently used to run the switch to a
snapshot
secondary device.
FACTORY DEFAULT IN PROGRESS
or
182.
command is a standard Junos OS operational mode command
request system zeroize
and returns to the
"Connecting and Configuring an
"Connecting and Configuring an EX
request system
, use the
request system
Copyright © 2017, Juniper Networks, Inc.
200,
Hide quick links:
Advertisement
Table of Contents
