EX2300-C and EX2300 Switches Hardware Guide
Table 44: Console Port Connector Pinout Information (continued)
Pin
Signal
6
RxD Input
7
CD Input
8
CTS Input
Related
Documentation
USB Port Specifications for an EX Series Switch
Related
Documentation
110
Description
Receive data
Data carrier detect
Clear to send
Connecting a Device to a Management Console by Using an RJ-45 Connector on page 168
Configuring the Console Port Type (CLI Procedure)
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port on all EX Series switches:
RE-USB-1G-S
RE-USB-2G-S
RE-USB-4G-S
CAUTION:
Any USB memory product not listed as supported for EX Series
switches has not been tested by Juniper Networks. The use of any
unsupported USB memory product could expose your EX Series switch to
unpredictable behavior. Juniper Networks Technical Assistance Center (JTAC)
can provide only limited support for issues related to unsupported hardware.
We strongly recommend that you use only supported USB flash drives.
All USB flash drives used on EX Series switches must have the following features:
USB 2.0 or later.
Formatted with a FAT or MS-DOS file system.
If the switch is running Junos OS Release 9.5 or earlier, the formatting method must
use a master boot record. Microsoft Windows formatting, by default, does not use a
master boot record. See the documentation for your USB flash drive for information
about how your USB flash drive is formatted.
EX2200 Switches Hardware Overview
EX2300 Switches Hardware Overview on page 3
Rear Panel of an EX3200 Switch
Rear Panel of an EX3300 Switch
Rear Panel of an EX3400 Switch
Copyright © 2017, Juniper Networks, Inc.