Mounting An Ex2300 Switch In A Recessed Position In A Rack Or Cabinet - Juniper EX2300-C Hardware Manual

Mounting an EX2300 Switch in a Recessed Position in a Rack or Cabinet

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
You can mount an EX2300 switch except the EX2300-C switch model on two posts or
four posts of a rack or cabinet such that the switch is recessed inside the rack from the
rack front by 2 inches. You can use the 2-in.-recess front-mounting brackets provided in
the separately orderable four-post rack-mount kit to mount the switch in a recessed
position.
Reasons that you might want to mount the switch in a recessed position include:
You are mounting the switch in a cabinet and the cabinet doors do not close completely
unless the switch is recessed.
The switch you are mounting has transceivers installed in the uplink ports—the
transceivers in the uplink ports protrude from the front of the switch.
To mount the switch in a recessed position on four posts, follow the instructions in
"Mounting an EX2300 Switch on Four Posts of a Rack or Cabinet" on page
the switch in a recessed position on two posts, follow the instructions in
EX2300 Switch on Two Posts of a Rack or Cabinet" on page
Connecting Earth Ground to an EX Series Switch on page 155
Rack-Mounting and Cabinet-Mounting Warnings on page 234
Chapter 12: Installing the Switch
137. To mount
"Mounting an
135.
153