Configuring Lpr Port Printing - Ricoh AFICIO AP306 Setup Manual

Windows NT 4.0 Configuration

Configuring LPR Port Printing

This section explains the procedure for printing to a LPR port from Windows
NT.
Note
The following procedure assumes that the printer drivers have already been
installed. This is the procedure to change the printer port to LPR.
The TCP/IP protocols must be installed and configured correctly. For more
information about configuring the protocol, see P.32 "Configuring TCP/IP and
3
IPP for Printing".
A
Click [Start], point to [Settings], and then click [Printers].
B
Click the icon of the printer you want to use. On the [File] menu, click [Prop-
erties].
C
Click the [Ports] tab, and then click [Add Port].
D
In the [Available Printer Ports] box, click "LPR Port", and then click [New Port].
Note
If "LPR Port" does not appear, "Microsoft TCP/IP Printing" has not been
installed.
E
Type the IP address of the Network Interface Board into the [Name or address
of server providing lpd] box.
F
Type "lp" into the [Name of printer or print queue on that server] box, and click
[OK].
G
Click [Close].
H
Confirm that the port name is displayed in the [Print to the following port(s)]
box and the check mark is inside the check box, and then click [OK].
44
Draft 2000/06/22