Ricoh AFICIO AP306 Setup Manual page 156

Troubleshooting
F
After confirming that "1.Con-
fig.Page" is displayed, press {Es-
cape}.
The following the message ap-
pears on the panel display.
<Menu>
List Print
G
You can find the crop marks on
the long edge of the configuration
page. Check if the left and right
margins on the long edge of the
4
configuration page are as shown
in the illustration.
H
If the left and right margins are
not the same, press {U} or {T} to
display "Maintenance", and then
press {Enter}.
<Menu>
Maintenance
The following message appears on
the panel display.
<Maintenance>
1.Reinstall
I
Press {T} or {U} to display
"4.Registration", and then press
{Enter}.
<Maintenance>
4.Registrationl
The following message appears on
the panel display.
<Registration>
Byps.:Vert.
70
J
Press {T} or {U} to display the
name of the tray whose margins
you want to balance, and then
press {Enter}.
The following message appears on
the panel display.
j
<Tray1:Horiz.>
l
jl/#
K
Press {U} or {T} to balance the
margins, and then press {Enter}.
One is equal to 0.2 mm.
Note
The "Vert." (vertical) setting
can be changed from -9 to +9,
and the "Horiz." (horizontal)
setting can be changed from -10
to +10.
L
Press {Enter}.
<Config.Page>
Press # key
j
This prints the configuration page
l
with the new setting and returns to
the "Registration" menu.
M
Confirm of the registration. If you
change the setting, press {Enter}
j
and repeat steps K and L. If you
l
finish, go to step N.
N
Press {On Line}.
The "Ready" message appears on
the panel display.
j
j
l
0
Draft 2000/06/22