Error & Status Messages On The Operation Panel - Ricoh AFICIO AP306 Setup Manual

Troubleshooting
Error & Status Messages on the Operation Panel
Important
If the error message that is not included in the following table appears on the
panel display, turn the printer off and on. If this does not clear the error mes-
sage, write down the error number and the message, and contact your sales
or service representative.
Note
The panel display can show only one error message at a time. Printing a con-
figuration page shows all current printer errors. ⇒ P.99 "Printing the Configu-
ration Page"
For more information about the IPDL-C printer driver, see the printer driver's
4
Help.
For more information about the RICOH-SCRIPT2 printer driver, see the "Op-
erating Instructions" for RICOH-SCRIPT2 included as a PDF file on the CD-
ROM.
Message
Add Fuser Oil
(on the upper line)
Add Fuser Oil
(on the lower line)
Add Toner
Please Wait
Add Toner
xxx
Call Service
SC:xx
Change Fuser
Change PCU.
38
Description
The fuser oil bottle is emp-
ty.
Fuser oil is low. You can
print about 200 or /more
pages after this message
appears.
The toner cartridge is being
prepared for replacement.
The indicated toner runs
out.
There is a malfunction in
the printer.
It is time to replace the fus-
ing unit.
It is time to replace the pho-
toconductor unit.
Comments
Replace the fuser oil bottle.
⇒ P.76 "Replacing the Fuser
Oil Bottle and Ozone Filter"
Replace the fuser oil bottle.
⇒ P.76 "Replacing the Fuser
Oil Bottle and Ozone Filter"
Wait for a while.
Replace the indicated toner
cartridge.
⇒ P.71 "Replacing Toner
Cartridge"
Turn the printer off and on.
If this does not clear the
problem, contact your sales
or service representative.
Contact your sales or ser-
vice representative.
If prints are dirty, replace
the photoconductor unit.
⇒ P.74 "Replacing the Photo-
conductor Unit"
Draft 2000/06/22