Table of Contents
Advertisement
Troubleshooting
Message
Paper Size Error
Please Wait
Power Off/On
4
Remove Misfeed
From Rear Cover
Remove Misfeed
Duplex Base Unit
Remove Misfeed
From Output Tray
Remove Misfeed
From Paper Tray
Reset Charger
Correctly
Reset Fusing
Unit Correctly
Reset PCU
Correctly
Reset Toner
Correctly
40
Description
There is a difference be-
tween the paper size in the
tray and the requested pa-
per size from the computer.
The printer is warming up
or processing internally.
There is a malfunction in
the printer.
There is a paper misfeed in
the rear cover.
*1
There is a paper misfeed in
the duplex tray.
*1
There is a paper misfeed in
the printer.
There is a paper misfeed in
the printer.
The charger is not set cor-
rectly or the charger clean-
er is not in the correct
position.
The fusing unit is not in-
stalled in the printer.
The photoconductor unit is
not installed in the printer.
The toner cartridge is not
installed correctly.
Comments
After confirming that the
size, feed direction of paper
and the paper size dial in
the tray are set correctly,
open and close the front
cover. ⇒ P.30 "Loading Pa-
per"
Wait until the printer re-
turns to the ready condi-
tion or processing
internally.
Turn the printer off and on.
If this does not clear the
problem, contact your sales
or service representative.
Remove the misfed paper.
⇒ P.64 "When the Message
"Remove Misfeed From Rear
Cover" Appears"
Remove the misfed paper.
⇒ P.63 "When the Message
"Remove Misfeed Duplex
Base Unit" Appears"
Remove the misfed paper.
⇒ P.60 "When the Message
"Remove Misfeed From Out-
put Tray" Appears"
Remove the misfed paper.
⇒ P.58 "When the Message
"Remove Misfeed From Paper
Tray" Appears"
Set the charger correctly. ⇒
P.80 "Replacing the Charger"
Contact your sales or ser-
vice representative.
Install the photoconductor
unit. ⇒ P.74 "Replacing the
Photoconductor Unit"
Install the cartridge cor-
rectly. ⇒ P.71 "Replacing
Toner Cartridge"
Draft 2000/06/22
Advertisement
Chapters
Table of Contents
