Netware 4.X, 5 - Advanced Settings - Ricoh AFICIO AP306 Setup Manual

NetWare Configuration

NetWare 4.x, 5 - Advanced Settings

The actual procedures for configuring the printer differ depending on whether
the Network Interface Board is configured as a print server or as a remote print-
er. This section describes how to configure it in the NetWare 4.x, 5 environment.
To use NetWare 5
• You cannot use the NDPS (Novell Distributed Print Services) mode.
• If you use Pure IP, configure the printer to use the TCP/IP protocol. For
more information about how to make the settings, see the "Setup Guide"
that comes with the printer.
Basic Procedure
4
Install the NIB Setup Tool
Print Server
Configure the Network Interface Board
Configure the NetWare
Turn the power
off and on
Preparation
The following procedures use the Property Sheet method in configuring the
Network Interface Board. If you configure the Network Interface Board as a
NetWare print server for the first time, we recommend you use the Wizard
method. ⇒ P.49 "Quick Setup Using the NIB Setup Tool Wizard"
Note
This section assumes NetWare is functional and that the necessary environ-
ment for the NetWare Print Service is available.
You should install the client software released from Novell on the Windows
before running the NIB Setup Tool for configuring in NDS mode or using
Windows NT 4.0.
58
Remote Printer
Start the print server
Draft 2000/06/22