Ricoh AFICIO AP306 Setup Manual page 129

Message
B7: Error
85:Error
86:Error
91:Error
94:Error
*1
This message appears when you use the duplex printer.
Note
If you cannot solve the problem by taking above actions, turn the printer off
and on. If this does not clear the error message, write down the error number
and the message, and contact your sales or service representative.
Description
An error has occurred in
the optional Network In-
terface Board.
The printer has run out of
frame memory. There is
not enough memory to ren-
der the graphic data.
You may be trying to print
with the wrong printer
driver.
You might not use the cor-
rect interface cable.
An error has occurred in
the printer's standard
memory.
The amount of the memory
is not set correctly.
Error & Status Messages
Comments
Turn the printer off and on.
Then, try to print again.
Turn off the printer. Re-
move and reinstall the Net-
work Interface Board and
turn on the printer. Then,
try to print again.
Turn off the printer. Re-
move the Network Inter-
face Board from the printer
and turn on the printer.
Then, try to print again.
Note
If you remove the Net-
work Interface Board,
you cannot print via the
network. You can send
the print job to the print-
er only via a parallel ca-
ble connection.
Reduce the size of the input
buffer, or add optional
memory.
Confirm that you are using
the correct printer driver.
Confirm that you are using
the correct interface cable.
Turn the printer off and on.
Then, try to print again.
Specify the correct amount
of memory using the print-
er driver.
Draft 2000/06/22
4
43