Table of Contents
Advertisement
Using the Operation Panel
5. Energy Saver
You can select after how many minutes the printer should enter the Energy
Saver mode if no operation is performed. The Energy Saver mode reduces
electric power consumption.
• Off
• 5min
• 15min
• 30min
• 45min
• 60min
Important
After the printer enters Energy Saver mode, it takes some time to warm up
again when print data is received.
6. Energy Level
5
You can select the Energy Saver mode level. "Level 1" is the default setting
and saves more power consumption than "Level 2".
• Level 1
• Level 2
Note
"Level 1" takes about six minutes to return to the ready condition.
"Level 2" takes about one minute to return to the ready condition.
7. PDL Sensing
You can set whether or not the printer will automatically switch the printer
language to the appropriate one for the print jobs.
• Auto
• Manual
8. Transfer
You can select the data transfer speed of the parallel interface. If you are hav-
ing trouble with data transfers, try changing this setting to "Normal".
• Hi-speed
• Normal
Note
This setting is effective only for "Parallel 1".
9. Parallel 1
You can select the parallel interface timing setting. Normally it is not neces-
sary to change this setting.
• ACK Inside
• ACK Outside
• STB Down
96
Draft 2000/06/22
Advertisement
Chapters
Table of Contents
