Table of Contents
Advertisement
Configuring IPP user authorization
Use the following command:
ipp user
The following message appears.
Input user number (1 to 10):
Type the number, user name and password.
IPP user name:user1
IPP password:*******
After configuring the settings, the following message appears.
User configuration changed.
Changing the password
Use the passwd command to change the remote maintenance password.
Important
Be sure not to forget or lose the password.
Note
The default factory password is "password".
A
Type "passwd".
msh> passwd
B
Type the current password.
Old password:
C
Type the new password.
New password:
Note
The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
The password is the same as that used in the configuration of the Network
Interface Board using a Web Browser and that used in the NIB Setup Tool.
If you change a password from telnet, the other passwords are also
changed.
D
Type the new password once again.
Retype new password:
Remote Maintenance by telnet
Draft 2000/06/22
6
85
Advertisement
Chapters
Table of Contents
