Connecting The Printer To The Network - Ricoh AFICIO AP306 Setup Manual

Note
If the interface board is not
properly installed, follow the
above procedure to reinstall it.
If you fail again, contact your
sales or service representative.
Connecting the Printer to the
Network
Follow these steps to connect the
printer to the network.
A
Confirm that you have the correct
network cable.
B
Confirm that the printer's power
switch is turned off. If it is on,
turn it off.
C
Loop the network cable. The loop
should be about 15 cm (6 inch)
from the end of the cable on the
end closest to the connector.
D
Attach the ferrite core to the loop.
E
Attach the network cable to the
10BASE-T/100BASE-TX port of
the printer.
F
Connect the other end of the cable
into the network.
TFWX980E
Installing the Interface Board
Draft 2000/06/22
2
21