Postscript Printing From Windows; Netware Printing - Ricoh AFICIO AP306 Setup Manual

Appendix

PostScript Printing from Windows

When printing PostScript from Windows, see the "Operating Instructions" for
RICOH-SCRIPT2 that comes with the printer for how to configure the Network
Interface Board and printer driver.

NetWare Printing

Form Feed
You should not configure the form feed on NetWare. The form feed is controlled
by the printer driver on Windows. If the NetWare form feed is configured, the
printer might not print properly. If you want to change the form feed setting, al-
ways configure it on Windows.
• With Windows 95/98, clear the [Form feed] check box on the [Printer Settings]
tab in the printer properties dialog box.
• With Windows 2000, clear the [Form feed] check box on the [Neware Settings]
tab in the printer properties dialog box.
6
• With Windows NT 4.0, clear the [Form feed] check box on the [Neware Settings]
tab in the printer properties dialog box.
Banner Page
You should not configure a banner page on NetWare. If you want to change the
banner page setting, always configure it on Windows.
• With Windows 95/98, clear the [Enable banner] check box on the [Printer Set-
tings] tab in the printer properties dialog box.
• With Windows 2000, clear the [Enable banner] check box on the [Neware Set-
tings] tab in the printer properties dialog box.
• With Windows NT 4.0, clear the [Enable banner] check box on the [Neware Set-
tings] tab in the printer properties dialog box.
Printing after resetting the printer
After resetting the remote printer, it will be cut off from the print server for about
30-40 seconds before connecting again. Due to the NetWare specification, print
jobs may be accepted, but they will not be printed during this interval.
When using the printer as a remote printer, wait about 2 minutes after resetting
the printer before attempting to print.
100
Draft 2000/06/22