Adjusting The Image Density - Ricoh AFICIO AP306 Setup Manual

C
Remove the cleaning brush from
back of the front cover.
D
Insert the cleaning brush into the
back of the light blue guide until
it stops, and then move it left and
right four or five times.
E
Return the cleaning brush to its
original position.
F
Holding the green inset grips of
the photoconductor unit, push the
unit back to its original position.
G
Close the front cover.

Adjusting the Image Density

Changing the image density setting
might cause a deterioration of color
balance. We recommend that you
normally leave the image density at
its factory default setting.
The following procedure describes
how to change the magenta image
density. You can use the same proce-
dure to change the image density for
TFWX270E
the other toner colors as well.
Important
Extreme settings may create out-
put that appears dirty.
Image density settings should be
made from the application or the
printer driver whenever possible.
A
Turn on the printer's power switch.
B
Press {Menu}.
TFWX280E
The following message appears on
the panel display.
<Menu>
IPDL-C Menu
C
Press {T} or {U} to display
"Maintenance", and then press
{Enter}.
<Menu>
Maintenance
Cleaning and Adjusting the Printer
j
l
j
l
Draft 2000/06/22
4
TFWS020E
67