ABB ACSM1 Manual page 325

Code Fault
(fieldbus code)
0067 FPGA ERROR1
(0x5401)
0068 FPGA ERROR2
(0x5402)
0069 ADC ERROR
(0x5403)
0073 ENC 1 PULSE
FREQUENCY
(0x738B)
0074 ENC 2 PULSE
FREQUENCY
(0x738C)
0075 MOT OVERFREQUENCY
(0x7390)
0201 T2 OVERLOAD
(0x0201)
0202 T3 OVERLOAD
(0x6100)
0203 T4 OVERLOAD
(0x6100)
0204 T5 OVERLOAD
(0x6100)
0205 A1 OVERLOAD
(0x6100)
0206 A2 OVERLOAD
(0x6100)
0207 A1 INIT FAULT
(0x6100)
Cause
Drive internal fault
Drive internal fault
Drive internal fault
Encoder 1 is receiving too high
data flow (pulse frequency).
Encoder 2 is receiving too high
data flow (pulse frequency).
Inverter output (motor)
frequency has exceeded the
frequency limit 599 Hz.
Firmware time level 2 overload
Note: This fault cannot be
reset.
Firmware time level 3 overload
Note: This fault cannot be
reset.
Firmware time level 4 overload
Note: This fault cannot be
reset.
Firmware time level 5 overload
Note: This fault cannot be
reset.
Application time level 1 fault
Note: This fault cannot be
reset.
Application time level 2 fault
Note: This fault cannot be
reset.
Application task creation fault
Note: This fault cannot be
reset.
What to do
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Check encoder settings.
Change parameters 93.03 ENC1 SP
CALCMODE and 93.13 ENC2 SP
CALCMODE to use only one channel pulses/
edges.
Check encoder settings.
Change parameters 93.03 ENC1 SP
CALCMODE and 93.13 ENC2 SP
CALCMODE to use only one channel pulses/
edges.
Reduce the motor rotation speed.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
325
Fault tracing