ABB ACSM1 Manual page 144

144
17.06 SIGNAL3 MODE
Defines the way the signal selected by parameter
optional control panel.
(-1) Disabled
(0) Normal
(1) Bar
(2) Drive name
(3) Drive type
Parameters and firmware blocks
FW block: None
17.01 SIGNAL1 PARAM
Signal not displayed. Any other signals that are not disabled are
shown together with their respective signal name.
Shows the signal as a numerical value followed by unit.
Shows the signal as a horizontal bar.
Shows the drive name. (The drive name can be set using the
DriveStudio PC tool.)
Shows the drive type.
is displayed on the