ABB ACSM1 Manual page 102

102
3.15 BRAKE COMMAND
Brake on/off command. 0 = Close. 1 = Open. For brake on/off control, connect this signal to a relay
output (or a digital output). See section
3.16 FLUX REF USED
Used flux reference in percent.
3.17 TORQUE REF USED
Used/limited torque reference in percent.
3.20 MAX SPEED REF
Maximum speed reference.
3.21 MIN SPEED REF
Minimum speed reference.
Parameters and firmware blocks
FW block: MECH BRAKE CTRL
Mechanical brake control
FW block: MOTOR CONTROL
FW block: MOTOR CONTROL
FW block: LIMITS (page 145)
FW block: LIMITS (page 145)
(page 186)
on page 55.
(page 189)
(page 189)