ABB ACSM1 Manual page 23

If the direction of rotation is selected as forward, check that the actual
speed (1.08 ENCODER 1 SPEED
positive:
• If the actual direction of rotation is forward and the actual speed
negative, the phasing of the pulse encoder wires is reversed.
• If the actual direction of rotation is reverse and the actual speed
negative, the motor cables are incorrectly connected.
Changing the connection:
Disconnect the main power, and wait for 5 minutes for the intermediate circuit
capacitors to discharge. Do the necessary changes. Switch the power on and start the
motor again. Check that the estimated and actual speed values are correct.
• If the direction of rotation is selected as reverse, the actual speed
must be negative.
Note: Resolver autotuning routines should always be performed after
resolver cable connection has been modified. Autotuning routines can
be activated by setting parameter
EXC SIGNAL FREQ, and then setting parameter
REFRESH to (1) Configure. If the resolver is used with a permanent
magnet motor, an Autophasing ID run should be performed as well.
Stop the motor.
Set parameter 22.01 SPEED FB SEL
speed.
If the speed feedback cannot be used in motor control: In special
applications parameter
TRUE.
Note: Speed filtering needs to be adjusted especially when the
encoder pulse number is small. See section
26.
If there is an emergency stop circuit in use, check that the circuit
functions (emergency stop signal is connected to the digital input
which is selected as the source for the emergency stop activation).
/ 1.10 ENCODER 2
92.02 EXC SIGNAL AMPL
to (1) Enc1 speed
40.06 FORCE OPEN LOOP
Emergency stop circuit
SPEED) is
or 92.03
90.10 ENC PAR
or (2) Enc2
must be set to
Speed filtering on page
23
1.08 ENCODER 1
SPEED /
1.10 ENCODER 2
SPEED
22.01 SPEED FB SEL
10.10 EM STOP OFF3 or
10.11 EM STOP OFF1
(emergency stop control
through fieldbus 2.12
FBA MAIN CW bits 2...4)
Start-up