Carburetor Assembly; Measuring And Adjusting The Fuel; Inspection Of The Fuel Wrench - Yamaha FZ-16 Service Manual

6. Install:
• Spring Iris "1"
• Cover the diaphragm "2", tighten the screws

CARBURETOR ASSEMBLY

1.Connect all wires and cables.
Refer to "REMOVAL
MOTOR "on page 5-2.
2.Ajustar
•
Set throttle cable free
Refer to "ADJUSTING THE GAME
THROTTLE CABLE FREE "
on page 3-6
3.Ajustar:
•
Engine idle
1300 to 1500 r / min.
Refer to "ADJUSTING THE IDLE
ENGINE "on page 3-4
MEASURING AND ADJUSTING THE
FUEL
1.Medir:
• Fuel level "a"
Out of specification - adjust
Fuel level (below the
contact surface of the chamber
Float)
6.0 ~ 7.0 mm
a. Place the vehicle on
flat.
b. Place the vehicle on the supporting
desirable to ensure that the vehicle
stay straight.
c. Install the fuel level gauge
"1" in the fuel drain hose "2"
d. Loosen the fuel drain "3"
e. Keep the fuel level gauge
vertically alongside the float chamber "4"
f. Measure the fuel level "a".
2
1
6-8
4
2.Ajustar:
•
Fuel level
a. Removing the carburetor.
b. Check valve seat of the needle
and needle valve.
c. If either is worn, replace
as a whole.
d. If both are fine adjust the level of
bending the pin float float "1".
e. Install the carburetor.
f. Measuring the fuel level again.
g. Repeat steps a through f until the
fuel level is within the
specifications.
1

INSPECTION OF THE FUEL WRENCH

1.Check:
• Key fuel
Cracks / damage / wear - replace.
CARB