Yamaha FZ-16 Service Manual page 51

1. Throttle cable
2. Cable sensor unit
3. Brake Hose
4. Speaker Cable
5. Cable high
6. Plug cap
7. Starter Cable
8. Starter relay cable
9. Fuse holder
10. Negative lead
11. Carburetor drain hose
12. Breather hose from the battery
13. Start relay
14. Brake switch
15. Battery
16. Harness
17. Cable regulator rectifier
18. Air Filter Cover
19. Regulator Rectifier
20. Carburetor breather hose
21. Positive cable
22. AC magneto lead
23. Ignition coil
24. Wire the ignition coil
25. Clutch cable
26. Cable throttle position sensor
27. Fuel meter cable
28. Battery Box
29. Cable brake switch
30. Detecting vacuum hose
31. AIS unit hose
A. Pass the wire harness through the guide
Air filter
B. Pass the wire harness, the negative lead to
through the rear hook of the box
battery
C. Adjust the white label wiring harness
with a clamp
D. Adjust the clamp on the back of
a motor support chassis
E. Opposite the bracket painted white
The vacuum hose 1 Detection
F. Route the starter relay and the motor
boot through the clamp on the
Battery box
GUIDING CABLES
G. Pass the breather hose and battery
the drain hose from the carburetor to
through the exterior of the motor
H. Pass the breather hose and battery
the drain hose from the carburetor to
here through the interior of
I. Attach the positive lead and the fuse holder with
Battery band
J. Pass the wire harness through the hook
in the battery box
K. Attach the throttle cable, rectifier,
wire harness and cable switch
brake chassis clamp
L. Pass the wiring harness through the
rear of the battery box
M. The wire harness passes through the slot
the air filter cover
N. Adjust the white label wiring harness
with the clamp on the right side of the box
Battery
O. Attach the negative wire and fuse. The cable
positive band of the battery
2-34