Removing The Front Fork Bars - Yamaha FZ-16 Service Manual

REMOVING THE BARS
FRONT FORK
The following procedure applies to both
Front fork bars
1.
I placed the vehicle on a flat surface
WARNING
Support the vehicle with safety to
there is no risk of falling.
2.
Loosen:
•
Screw top bracket "1"
•
Screw bottom bracket "2"
WARNING
Before loosening the mounting screws
upper and lower rods hold the
front fork.
NOTE:
To facilitate removal of stop screws,
first loosen the screw on top, then
loosen the cap slightly without loosening the
bottom bracket screw while the fork
front is installed in the vehicle.
2
3.
Remove:
•
Front fork bars
DISASSEMBLY OF THE BARS
FRONT FORK
The following procedure applies to both
Front fork bars
1.
Remove:
•
Rubber cover
•
Clip "1"
•
Cover front fork "2"
(With O-ring)
•
Spring fork.
2.
Drain:
•
Fork oil
NOTE:
Operate the outer tube several times while
leaving the fork oil
3.
Remove:
•
Dust "1"
•
Oil seal clip "2"
(With a flathead screwdriver)
CAUTION
Do not scratch the inner tube.
1
4.
Remove:
•
Screw rod of the damper "1"
•
Damper rod
4-38
FRONT FORK
1
2