Beam Adjustment Of Farola; Auxiliary Light Replacement; Change Bulb Rear / Bulb Brake; Electrical System - Yamaha FZ-16 Service Manual

4. Assembly:
•Lamp bulb
Secure the lamp bulb again
the lamp bulb holder
CAUTION:
Avoid touching the glass bulb of the
Cembran to keep it free of oil, it
otherwise the transparency of glass, the life of
bulb and the brightness will be affected
negatively. If the lamp bulb is dirty,
thoroughly clean with a cloth moistened with alcohol or
a lacquer thinner.
5. Assembly:
•
Lamp bulb holder
6. Assembly:
•
Lamp bulb cover

BEAM ADJUSTMENT OF FAROLA

The following procedure applies to adjust
the light beam of the lamp.
Loosen the screw and move the lamp
the lamp in the following manner to adjust the
beam of the lamp
Address to
The beam of light from the lamp low
Address b
The beam of light from the lamp goes
to

ELECTRICAL SYSTEM

AUXILIARY LIGHT REPLACEMENT

The following procedure applies to the bulb
low beam and high beam.
1. Remove:
•Side covers (See change
bulb of the lamp) on page 3-22
•The connections of the signal indicating
turn (See change the bulb
lamp) on page 3-22
2. Remove:
• Bulb auxiliary "1 as shown in
illustration ".
1
CHANGE BULB REAR / BULB
BRAKE
1. Remove:
•Screw "1"
•Lens "2"
2. Push the bulb "1" and turn gently
counterclockwise.
3-23
1
2
1