Yamaha FZ-16 Service Manual page 120

7.
Assembly:
• New
Dust "1"
(With the Seal assembly tool of
Front fork oil "2")
Seal assembly tool
of the front fork oil
YSST-875
New
8.
Filling:
• Sweep the front fork
(With the specified amount of oil
recommended)
Recommended Oil
Oil 10W or suspension
equivalent
Number 459 cm3
CAUTION
Be sure to use oil suspension
recommended. Other oils may have
an adverse effect on the performance of the
front fork.
When disassembling and assembling the bars
front fork, not perrmita that
foreign materials from entering the fork
front.
9.
After filling the fork leg
front, slowly pull the inner tube
"1" from top to bottom (at least ten times)
to distribute the oil suspension.
NOTE:
Sure to operate the inner tube slowly
because the oil can flow suspension.
FRONT FORK
10.Antes
measure the level of fork oil,
wait ten minutes until the oil has
settled and the air bubbles has dispersed.
NOTE:
Be sure to purge the fork leg
front of any residual air.
11.
Measure:
•
Oil level of the fork leg
front "a" (from the top of the tube
inside, with the inner tube fully
compressed without fork spring)
Correct out of specification.
Level
87.0 mm
12.
Assembly:
• R
fork esorte "1"
NOTE:
Install the spring with the end of smaller height
"A" down
1
4-41
to