Inspection Of Clutch Springs; Inspection Of The Clutch Hood; Inspection Of Caddy Clutch; Inspection Of Pressure Plate - Yamaha FZ-16 Service Manual

Thickness of clutch discs
1.85-2.15 mm
Limit deformation
0.20 mm
INSPECTION OF SPRINGS
CLUTCH
The following procedure applies to all
clutch springs.
1.
Check:
•
Clutch springs
Replace damaged clutch springs
as a set
2.
Measure:
•
Free length of the clutch springs "a"
EspecificaciónReemplace outside the
clutch springs as a whole
Free length of the springs
clutch
41.60 mm
Minimum length
40.60 mm
INSPECTION OF THE HOOD
CLUTCH
1.
Check:
•
Lace the clutch "1"
Damage / pitting / wear Deburring
lace of the clutch or
replace the clutch.
NOTE:
Pitting in lace bell
will cause erratic clutch operation
clutch.
2.
Check:
•
Bearing
Damage / wear Replace the bearing
and the clutch.
INSPECTION OF caddy
CLUTCH
1.
Check:
•
Lace Clutch cutterbar of
Damage / pitting / wear Replace
the clutch disc carrier.
NOTE:
Pitting in the lace of the disc holder
will cause erratic clutch operation
clutch.

INSPECTION OF PRESSURE PLATE

1.
Check:
•
Pressure Plate
Cracks / damage Replace the plate
pressure.
INSPECTION OF GEAR DRIVE
PRIMARY
1.
Check:
•
Pressure Plate
•
Cracks / damage Replace the plate
pressure.
INSPECTION OF GEAR DRIVE
PRIMARY
1.
Remove:
•
Primary drive gear
See "THE BALANCER GEAR"
on page 5-49.
5-39
CLUTCH