Yamaha FZ-16 Service Manual page 178

5.
Bend the tab washer
along a flat side of the nut.
6.
Lubricate:
•
Friction discs
•
Clutch discs
(With the recommended lubricant)
Recommended lubricant
Engine Oil
7. Install:
•
Seat cushion spring
clutch "1"
• clutch damper spring "2"
• friction discs 2
• Clutch discs
• friction discs 1
NOTE:
• Install the spring seat cushion
clutch and spring damper
clutch as shown in the illustration.
First, install a friction disc and •
then switch between a clutch plate and a
friction disc.
8. Install:
• Pressure Plate
• Clutch Springs "1"
• Screw clutch springs "2"
Springs screws
clutch
8 Nm (0.8 m · kg, 6 ft · lb)
T.
R.
NOTE:
Tighten the clutch springs
in stages and in a cross pattern.
9.
Fit:
•
Free play of the clutch mechanism
a.
Verify that the projection "a" in the lever
Clutch "1" is aligned with the mark "b"
shown in Figure crankcase
pushing the push lever clutch
manually in the direction "c" until
stops.
b.
If the projection "a" is not aligned with the
brand name "b", align follows:
•
Loosen the lock nut "2".
•
With the push lever clutch
completely pushed in the direction "c",
rotate the push rod clutch short
"3" inward or outward until the
projection "a" is aligned with the mark "b".
•
Hold the short rod thrust
clutch to prevent movement and torque
12
nut to specification.
5-41
to
b
Nut (short rod
Clutch thrust)
8 Nm (0.8 m · kg, 5.8 ft · lb)
T.
R
2
3
CLUTCH
2
1
c
1