Yamaha FZ-16 Service Manual page 103

1
2.
Ensemble:
New
Copper washers "1"
Brake hose "2"
Screw attachment of the brake hose "3"
Screw connection of the hose
brake 26 Nm (2.6 m · kg, 19 ft · lb)
T.
R.
WARNING
A correct guidance is essential for
safe vehicle operation
NOTE:
Brake hose assembly to the front
the master cylinder at the angle shown in
Figure
While holding the brake hose, tighten
the connecting screw of the brake hose
as shown.
Turn the handlebar to the left and right to
ensure that the brake hose does not touch
other parts (eg, harness of cables, wires,
drivers). Corrected if necessary.
2
1
2
3.
Fill:
Deposit brake master cylinder (with the
specified amount and recommended
brake fluid)
Liquid preferred
DOT 3 or DOT 4
WARNING
Use solame efore the brake fluid
recommended, some brake fluid may
cause damage to rubber seals,
causing leaks and loss of efficiency
elfrenado.
Refill with the same type of brake fluid
that is already in the system, the mixture
fluids can cause a chemical reaction
operation that would cause harmful
Brake incorrect
When complete, use caution to
no water in the master cylinder.
The water significantly decreases the point
boiling of the fluid and may cause
in vapor.
CAUTION
Brake fluid can damage the surfaces
painted or plastic. Immediately clean
any spilled brake fluid.
4.
Purge:
Brake system
See "PURGING SYSTEM
HYDRAULIC BRAKE "on page 3-15.
5.
Check:
Brake fluid level
Below the minimum level mark "to" Add
recommended brake fluid to the proper level.
Refer to "CHECKING THE LEVEL
BRAKE FLUID "on page 3-14
3
6.
Check:
Operation of the brake lever
Soft or spongy feeling Bleed
Brake system
4-24
FRONT BRAKE
Max.
Min