Checking The Front Brake Pads; Checking The Front Brake Hose; Bleeding The Hydraulic Brake System; Adjusting The Rear Brake Light Switch - Yamaha FZ-16 Service Manual

CHECKING THE BRAKE
FRONT
The procedure applies to all
brake pads.
1.
Operate the front brake.
2.
Check:
Front brake pads
Tread wear indicators "1" almost touch the
Replace brake disc game
brake pads. See
"FRONT BRAKE" on page 4-20
1
CHECKING THE BRAKE HOSE
1.
Check:
Brake Hose
Cracks / damage / desgasteReemplazar
U
T
U
T
2.
Check
Clamp the brake hose
Loose Tighten the clamp
3.
Support the vehicle and apply the brake
front several times.
4.
Check:
Brake Hose
Leaking brake fluid Replace
See damaged hose
"FRONT BRAKE" on page 4-16
CHECKING BRAKE BANDS
REAR
1.
Operate the front brake.
2.
Check:
Tread wear indicators "1" strips
brake
Reaches the wear limit mark "2"
Replace the brake bands game.
Refer to "FRONT BRAKE"
on page 4-26
ADJUSTING THE LIGHT SWITCH
REAR BRAKE
NOTE:
The rear brake switch is actuated by
the movement of the brake pedal. When the
light switch rear brake is set
correctly, when the light comes on
immediately before the start of braking effect.
1.
Check:
Operation of the brake light.
Wrong Set.
2.
Fit:
Operation of the brake light
a.
Hold the main body "1" switch
1
rear brake and turn the adjusting nut "2"
in the direction "a" or "b" until the brake light
lights at the right time.
2
Direction "a"
Brake light comes on before.
Direction "b"
Brake light comes on later.
BLEEDING BRAKE SYSTEM
HYDRAULIC
WARNING
Make the drain hydraulic brake system
provided that: The system is disassembled.
A brake hose is removed,
removed or replaced.
The brake fluid level is very low.
Braking is not adequate.
3-15
CHASSIS
2
1