Important Information; Preparing For The Removal And Disassembly; Replacement Parts; Packing, Oil Seals And O-Rings - Yamaha FZ-16 Service Manual

IMPORTANT INFORMATION

PREPARING FOR THE REMOVAL AND
DISASSEMBLY
1. Before you remove and disassemble, clean
all dirt, mud, dust and material
strangers.
2. Use only the proper tools and
clean equipment.
See "TOOLS
SPECIAL "on page 1-8.
3. When disassembling, always keep
together the pieces of the same whole. This
includes gears, cylinders, pistons and other
working parts "grouped" by the use
normal. The parts must always grouped
be reused or replaced altogether.
4. During disassembly, clean all
pieces and place them in trays in the order of
removal. This will speed up assembly and allow
the correct assembly of all parts
5. Keep all parts away from any
fire source.

REPLACEMENT PARTS

Use only genuine Yamaha parts in all
changes. Use oil and grease
recommended by Yamaha, for all
.
lubrication services. Other brands may
be similar in function and appearance, but
inferior in quality.
IMPORTANT INFORMATION
PACKING, OIL SEALS AND O RINGS
1. When assembling the engine, replace all
gaskets, oil seals and O-rings. All
surfaces of packaging, seal edges
Oil and O-rings must be cleaned.
2. During assembly, place the oil
specified on all parts and bearings
carefully and lubricate the edges of the
oil them with grease.
WASHER SAFETY LOCKNUTS

AND PINS

After disarming, replace all washers
safety pins and "1". After which
set screw or nut to the torque
specified, fold the side edges against
side of the screw or nut.
1-3